The information you are about to copy is INTERNAL!
DO NOT share it with anyone outside Check Point.
VSX supported features
Technical Level
Solution ID
sk79700
Technical Level
Product
VSX, Quantum Appliances, Quantum Security Gateways
Version
R77.20, R80.10 (EOL), R80.20, R80.30, R80.40, R81, R81.10
OS
Gaia
Platform / Model
2000, 3000, 4000, 5000, 12000, 13000, 15000, 21000, 23000, 41000, 44000, 61000, 64000, 6000, 7000, 16000, 26000, 28000
Date Created
19-Jul-2012
Last Modified
20-Apr-2022
Solution
The VSX mode is supported only on Security Gateways that run on these Operating Systems:
Check Point Gaia OS (from R75.40VS and higher)
X-Series XOS (from R75.40VS to R77.30)
The table below shows the Software Blades and Features supported in the VSX mode (read the notes under the table).
Enter the string to filter this table:
Notes:
In this version, this Software Blade / Feature is not supported on X-Series XOS.
For this version, refer to sk106496 - Software Blades updates - FAQ .
In this version, the Mobile Access Software Blade is supported partially. Refer to:
X-Series XOS uses its own routing suite (Gaia OS uses the RouteD daemon).
In this version, Gaia Portal is supported only to run the Gaia 'First Time Configuration Wizard'.
In this version, IPv6 is supported with these limitations:
Pure IPv6 is not supported (must have IPv4 addresses assigned) - applies only to Clusters.
IPv6 is not supported on Virtual Routers.
VRRP cluster in VSX mode is supported only on X-Series XOS.
For information about 60000 / 40000 Security Systems, refer to the corresponding Release Notes (41000 , 44000 , 61000 , 64000 ) - chapter "System Requirements" - section "Gateway Requirements" - subsection "Supported Software Blades".
For this version, refer to sk106496 - Software Blades updates - FAQ and to the VSX Administration Guide for your version.
For this version, refer to the VSX Administration Guide for your version (R80.40 and lower).
For this version, refer to sk32027 - NTP Server support on Gaia and SecurePlatform OS .
For this version, refer to sk97494 - Gaia "Cloning Groups" are not supported on Security Gateway in VSX mode .
For this version, refer to sk100500 - Policy-Based Routing (PBR) on Gaia OS .
For this version, refer to sk110351 - Traffic latency on VSX Gateway if MTU larger than 4096 (Jumbo Frames) is configured on an interface .
Because "Compliance" Software Blade is a Management blade, you cannot activate it in a VSX Gateway / VSX Cluster object. "Compliance" Software Blade supports VSX Gateways / VSX Clusters running R77.20 and higher. By design, the "Security Best Practices" for "Gaia OS" are not checked on VSX Gateways / VSX Clusters. Refer to sk92861 - ATRG: Compliance Blade .
Scalable Platforms support this Software Blade only in R76SP.40, R76SP.50, R80.20SP, R80.30SP, R81 and higher. For R76SP.40 and R76SP.50 versions, follow the instructions in sk111405 - 60000 / 40000 Appliances - How to enable Threat Emulation blade on R76SP.40 and R76SP.50 .
In this version, Gaia Portal is supported only to install CPUSE packages.
Related documentation:
Related solutions: