Support Center > Search Results > SecureKnowledge Details
"Unknown field" error pops up when configuring an SMB appliance's IPS load thresholds in the WebUI
Symptoms
  • "Unknown field" error pops up when the user configures an SMB appliance's IPS load thresholds in the WebUI:

    Note: This issue occurs only on the following firmware versions:

    • R77.20.85 
    • R77.20.86
    • R77.20.87 (< Build 990172914)
Cause

 


Solution

This problem was fixed. The fix is included in:

Check Point recommends to always upgrade to the most recent version (Check Point 700 appliance / Check Point 910 appliance / Check Point 1400 appliance).

If you do not wish to upgrade, use the following workaround:

In Clish mode, manually configure the relevant commands of the IPS load thresholds (refer to the CLI guide).

 

 

 This solution has been verified for the specific scenario, described by the combination of Product, Version and Symptoms. It may not work in other scenarios.

Give us Feedback
Please rate this document
[1=Worst,5=Best]
Comment