Support Center > Search Results > SecureKnowledge Details
SandBlast Zero-day Protection Threat Emulation in 1200R/1400 SMB appliances managed by R77.30 Security Management / Multi-Domain Management Technical Level
Solution

Centrally managed 1200R and 1400 SMB appliances support the SandBlast zero-day protection Threat Emulation blade. 

To add the Threat Emulation support for SMB appliances to R77.30 Security Management Server and SmartDashboard, download and install the below hotfix.

Package Download
R77.30 Management HotFix CPUSE Offline package: (TGZ)

CPUSE Online Identifier:
Check_Point_R77.30_smb_Hotfix_sk117113_FULL.tgz

CLI Installation:  (TGZ)
R77.30 SmartDashboard   (ZIP)

Notes:

  • This hotfix should be installed over Security Management Server R77.30 on top of Jumbo HFA Take 286.
  • This hotfix adds 1430/1450, 1470/1490 models to the Platform Hardware Type list (for more information refer to sk111292).
  • This hotfix requires to re-install SmartConsole on all GUI client machines that connect to this Security Management / Multi-Domain Management server.


Installation Instructions:

  1. Close the SmartDashboard.

  2. Important: Make sure that R77.30 Management Add-On is installed on your Security Management / Multi-Domain Management server.
    Note: On Multi-Domain Management server, this Add-On must be manually activated on the relevant Domain.

  3. Download the R77.30 Management hotfix from the table above and install it on the Security Management / Multi-Domain Management server.

  4. Uninstall the current R77.30 SmartDashboard on all GUI client machines that connect to this Security Management / Multi-Domain Management server.

  5. Download the improved R77.30 SmartDashboard from the table above and install it.

  6. Open the SmartDashboard and verify that appliances list is updated.

Note: Make sure that the gateway runs firmware R77.20.51 and higher (refer to sk114815)

Give us Feedback
Please rate this document
[1=Worst,5=Best]
Comment