Support Center > Search Results > SecureKnowledge Details
Configuring PIM Sparse Mode with dynamic Rendezvous Point (RP) fails in cluster environment
Symptoms
  • Configuring PIM Sparse Mode with dynamic Rendezvous Point (RP) fails in cluster environment.

  • "RTGRTG0019 PIM: the IP address must be an IPV4 local address matching a PIM interface or a loopback address not in 127.0.0.0/8" error when executing the following Clish commands:

    • set pim candidate-rp local-address <Cluster_VIP_Address>
    • set pim bootstrap-candidate local-address <Cluster_VIP_Address>
  • Using the Cluster VIP address in Gaia Portal for Candidate Rendezvous Point / Bootstrap Router fails as well.

  • The Gaia Portal "PIM" page (in "Advanced Routing" section) hangs/freezes when configuring ClusterXL as PIM Router + Dynamic Rendezvous Point + Bootstrap Router (per sk100239 - section "(3-2-C)").
    If users cancels the configuration, then all options on the "PIM" page become grayed out.

Cause
Interface validation fails.
  1. Cluster VIP addresses are not treated as interfaces capable of running PIM.
  2. Defined IPv4 address are not fully validated to belong to a PIM-enabled interface.

Solution
Note: To view this solution you need to Sign In .